Huawei Switch Ethernet Port Configuration88

Ethernet ports are the physical interfaces on a Huawei switch that allow it to connect to other network devices. Each Ethernet port has a unique MAC address and IP address, and can be configured to operate at different speeds and modes. The following steps will guide you through the process of configuring Ethernet ports on a Huawei switch:

1. Connect to the switch

Use a console cable to connect to the switch's console port. The default login credentials are username: "admin" and password: "admin".

2. Enter the switch configuration mode

Enter the following command to enter the switch configuration mode:```
switch# configure terminal
```

3. Configure the Ethernet port

Use the following command to configure an Ethernet port:```
switch(config)# interface Ethernet 0/0
```

Replace "Ethernet 0/0" with the actual Ethernet port you want to configure.

4. Configure the IP address

Use the following command to configure the IP address and subnet mask for the Ethernet port:```
switch(config-if)# ip address 192.168.1.1 255.255.255.0
```

Replace "192.168.1.1" and "255.255.255.0" with the actual IP address and subnet mask you want to use.

5. Configure the speed and duplex

Use the following command to configure the speed and duplex settings for the Ethernet port:```
switch(config-if)# speed 100
switch(config-if)# duplex full
```

Replace "100" with the desired speed (in Mbps) and "full" with the desired duplex mode (full or half).

6. Exit the configuration mode

Use the following command to exit the switch configuration mode:```
switch(config-if)# exit
```

7. Save the configuration

Use the following command to save the configuration changes:```
switch# copy running-config startup-config
```

Additional configuration options

The following additional configuration options can be applied to Ethernet ports on a Huawei switch:* VLAN configuration: Use the "vlan" command to assign a VLAN to the Ethernet port.
* QoS configuration: Use the "qos" command to configure QoS settings for the Ethernet port.
* Security configuration: Use the "security" command to configure security settings for the Ethernet port.

Verifying the configuration

Use the following commands to verify the configuration of an Ethernet port:```
switch# show interface Ethernet 0/0
switch# show ip interface Ethernet 0/0
```

These commands will display the current configuration of the Ethernet port, including the IP address, speed, duplex, and VLAN settings.

2025-02-07

Previous：What Does “UNI“ Mean in Cryptocurrency?

Next：Bitcoin and its Inverse Counterpart